FH-3380 polyol is a high molecular weight, primary hydroxyl terminated triol. The
combination of FH series bio-based polyols, and high molecular weight and reactivity makes FH-3380 useful in the preparation of elastomers and HR molded foams. FH-3380 has been formulated with a specialty inhibitor package which is not recommended for flexible slabstock foam production.
Typical properties
Appearance | clear liquid |
Hydroxyl number, mg KOH/g | 24.0 – 26.0 |
Water wt.% maximum | 0.05 |
Acid number, maximum | 0.030-0.035 |
Na & K, ppm maximum | 5 |
Color, APHA maximum | 30 |
Nominal functionality | 3 |
Nominal molecular weight | 6500 |
Density, lbs/gal @ 25°C | 8.49 |
Density, lbs/gal @ 38°C | 8.40 |
Density, lbs/gal @ 60°C | 8.25 |
Viscosity, cps @ 25°C | 1370 |
Viscosity, cps @ 38°C | 790 |
Viscosity, cps @ 60°C | 373 |
Application
High resilience foam
Molded foam
Elastomer
Storage and transportation
FH-3380 should be stored under dry conditions below 60°C.
200kg nonreturnable steel drums, 1000kg IBC tank made from HWHDPE.
Attention
These products can be used to prepare a variety of polyurethane products. Polyurethanes are organic materials and must be considered combustible.
This product is sold solely for use by industrial institutions. Refer to our Safety Data Sheet (SDS) regarding regulatory compliance, safety, hazards, spill procedures and disposal of this product. An SDS as well as additional information on Hug Chem polyols may be obtained by contacting us.
