Combined with bio-based polyol, FH-60260 Polyol is a polyether triol with an average molecular weight of 260.
FH-60260 Polyol is used for the preparation of compact and foamed rigid urethanes. Typical end uses include floorings, structural castings and coatings, especially when a high rigidity is required and rigid urethane foams. FH-60260 Polyol can also be used in blends with other FH series polyols to influence physical and mechanical properties.
Storage Note: This product has shown tendencies to become turbid and crystals may form if stored at temperatures below 18°C. However, these trends can be reversed without affecting product quality, by gentle heating.
Typical properties
Property | Value |
Hydroxyl number, mg KOH/g | 647-676 |
Water max. % | 0.10 |
Acid number, max. mg KOH/g | 0.05 |
APHA color, max. | 30 |
Viscosity, cSt, 25°C | 830-980-300 |
Specific Gravity, 25°C | 1.05 |
Flash point (PMCC) | 210°C |
Application
Foam
Coating
Adhesive
Safety considerations
Most FH series polyols generally present no significant hazard in use when simple precautions are followed. However, some FH series polyols are hazardous and before working with these systems it is necessary to understand the hazards involved in handling all of the components and to establish and follow safe work procedures. Material Safety Data Sheets, product literature and safe handling and storage information are available for the polyurethane components supplied by Hug Chem. Recommendations for handling, storage and disposal of any ingredient not furnished by Hug Chem should be acquired from the supplier.
Storage and Packaging
FH-60260 polyol is slightly hygroscopic and may absorb water. Containers should be kept tightly closed and protected from contamination with moisture and foreign materials, which can adversely affect processing. This product can become quite viscous at low temperatures. For ease of handling, storage temperatures between 15°C (59°F) and 60°C (140°F) are recommended.
The shelf life is twelve months after receipt of material by customer, when stored in sealed original containers under conditions stated above.
200kg nonreturnable steel drums, 1000kg IBC tank made from HWHDPE.
Health and safety information
Appropriate literature has been assembled which provides information concerning the health and safety precautions that must be observed when handling this product. Before working with this product, you must read and become familiar with the available information on its risks, proper use, and handling. This cannot be overemphasized. Information is available in several forms, e.g., safety data sheets and product labels. For further information contact Service of Hug Chem.
