Combined with FH series bio-based polyol, FH-1710 is formed by adding propylene oxide to a propylene glycol nucleus. FH-1710 is used in the preparation of polyurethane foams, binders, coatings, elastomers and sealants.
Typical properties
Appearance | clear liquid |
Hydroxyl number, mg KOH/g | 150 – 150 |
Water wt.% maximum | 0.05 |
Acid number, maximum | 0.015 |
Na & K, ppm maximum | 5 |
Color, APHA maximum | 50 |
Nominal functionality | 2 |
Nominal molecular weight | 700 |
Density, lbs/gal @ 25°C | 8.36 |
Density, lbs/gal @ 38°C | 8.26 |
Density, lbs/gal @ 60°C | 8.15 |
Viscosity, cps @ 25°C | 129 |
Viscosity, cps @ 38°C | 3960 |
Viscosity, cps @ 60°C | 1827 |
Storage and transportation
FH-1710 should be stored under dry conditions below 60°C.
200kg nonreturnable steel drums, 1000kg IBC tank made from HWHDPE.
Attention
These products can be used to prepare a variety of polyurethane products. Polyurethanes are organic materials and must be considered combustible.
This product is sold solely for use by industrial institutions. Refer to our Safety Data Sheet (SDS) regarding regulatory compliance, safety, hazards, spill procedures and disposal of this product. An SDS as well as additional information on Hug Chem polyols may be obtained by contacting us.
